User's Manual

HotPoint Wireless Access Point 13
Physical AP Radio Settings
Each physical AP has certain radio settings which are common to all virtual
APs on that node. These are set using the AP Configuration command, as
shown at right.
Auto Channel allows the AP to find the clearest channel, or you may set the
channel manually.
The Wireless Mode can be set to b, b/g, g-only, or 108g Static Turbo.
The raw Transmit Data Rate of the wireless link can also be specified.
Transmitter power and beacon can be controlled.
Antenna Diversity is supported. This control determines which antenna the
unit listens on; transmit is always on Antenna 1. In most cases, Diversity
is the best choice, but if you are only installing one antenna, set this to
Antenna 1.
Rogue AP Detection enables the AP to detect other, “unknown” APs oper-
ating in the area, and report them. You may specifiy how often the AP stops
and scans for rogue APs, as well as the level of search.