User's Manual Part 2
40 HotPoint 5000 User Guide January 2011
Appendix D Regulatory Notices
FCC Part 15 Note
These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.
FCC Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure
To ensure compliance with the FCC’s RF exposure limits, the antenna used for this transmitter must be installed to provide a separation
distance of at least 40 cm from all persons and must not be co-located or operated in conjunction with any other antenna or transmit-
ter. Installers and end users must follow these installation instructions.
Modications
Any modications made to this device that are not approved by Firetide, Inc. may void the authority granted to the user by the FCC
to operate this equipment.
Installation
Antenna(s) for the Model 5200 outdoor unit must be installed by a qualied professional. Operation of the unit with non- approved
antennas is a violation of U.S. FCC Rules, Part 15.203(c), Code of Federal Regulations, Title 47.
Canadian Compliance Statement
This Class A Digital apparatus meets all the requirements of the Cana-
dian Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe A respecte les exigences du Reglement
sur le material broilleur du Canada.
The device for operation in the band 5150-5250 MHz is only for
indoor use to reduce the potential for harmful interference to co-
channel mobile satellite systems.
L’artice pour l’opération dans la bande 5150-5250 MHz est seulement pour
l’utilisation en salle pour réduire le potentiel pour l’interférence malfai-
sante au radiotéléphone de co-canal les systèmes satellites.
The maximum antenna gain permitted for devices in the bands 5250-
5350 MHz and 5470-5725 MHz shall comply with the EIRP limit.
l’augmentation d’antenne maximum permise pour les artices dans les
bandes 5250-5350 MHz et 5470-5725 MHz se pliera à la limite d’e.i.r.p.
The maximum antenna gain permitted for devices in the band 5725-
5825 MHz shall comply with the EIRP limit specied for point-to-
point and non point-to-point operation as appropriate.
l’augmentation d’antenne maximum permise pour les artices dans la
bande 5725-5825 MHz se pliera aux limites d’e.i.r.p. spéciées pour le
point-à-point et non l’opération de point-à-point comme appropriées.
Firetide 5100 and 5200 devices are certied to the requirements of
RSS-210 for 2.4 GHz spread spectrum devices. The use of this device in
a system operating either partially or completely outdoors may require
the user to obtain a license for the system according to the Canadian
regulations. For further information, contact your local Industry Canada
ofce.
Dispositifs Firetide 5100 et 5200 sont certiés selon les exigences du CNR-
210 pour les périphériques 2,4 GHz à étalement de spectre. L’utilisation de
ce dispositif dans un système d’exploitation, partiellement ou complète-
ment à l’extérieur peut obliger l’utilisateur à obtenir une licence pour le
système en fonction de la réglementation canadienne. Pour de plus amples
renseignements, communiquez avec votre bureau d’Industrie Canada.
NCC Statement
一、經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
二、低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設 備之干擾。