User's Manual

July 2011 Firetide. Reliable Connectivity Anywhere. 15
Installing the Radio Unit
The radio unit mounts with a two-piece mounting assembly. One half of the assembly is permanently at-
tached to a pole or wall; the second half, on the radio itself, hooks over the rst.
Figure 6. Two-Piece Radio Mounting Plate Assembly
Hooks
(4)
Hook
Attachments
(4)
Radio w/ Mounting Plate
Mount-Plate
Captive Screws
(4)
Radio as shipped
The FWB-205 is shipped with a two-piece mounting plate already attached, as shown. Loosen the four
fasteners, two on each side, to remove the hook-attachment plate. The captive screws are tight; you will
need a Phillips screwdriver, or channel-lock or slip-joint pliers.
Attach two U-bolt assemblies to the mounting pole, as shown in Figure 7. The U-bolts are large enough to
accomodate large poles; if you are mounitng on a smaller-diameter pole, you must either cut the U-bolts
to length or use four additional spacer nutes, as shown at right in Figure 7.
Figure 7. U-Bolt Attachment to Pole, Spacer Nuts on U-Bolts
Now you can hang the radio unit on the bracket, and tighten the four captive screws.