User's Manual

July 2011 Firetide. Reliable Connectivity Anywhere. 19
5.3 Regulatory Notices
FCC Part 15 Note
These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause unde-
sired operation.
FCC Class B Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure
To ensure compliance with the FCC’s RF exposure limits, the antenna used for this transmitter must be
installed to provide a separation distance of at least 76 cm from all persons and must not be co-located
or operated in conjunction with any other antenna or transmitter. Installers and end users must follow
these installation instructions.
Modications
Any modications made to this device that are not approved by Firetide, Inc. may void the authority
granted to the user by the FCC to operate this equipment.
Installation
The FWB-205 Kit and its two 19 dBi antennas are intended for xed, point-to-point applications only. Any
other use is prohibited. Antenna(s) for the FWB-205 outdoor unit must be installed by a qualied profes-
sional. Operation of the unit with non-approved antennas is a violation of U.S. FCC Rules, Part 15.203(c),
Code of Federal Regulations, Title 47.
Canadian Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment
Regulations. Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material
broilleur du Canada.
FWB-205 devices are certied to the requirements of RSS-210 for 2.4 GHz spread spectrum devices. The
use of this device in a system operating either partially or completely outdoors may require the user to
obtain a license for the system according to the Canadian regulations. For further information, contact
your local Industry Canada ofce.
NCC Statement
一、經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
二、低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改
善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設 備之干擾。