Instructions / Assembly
Glass
Frame
Finial
Decorative Nuts
Socket
Machine Screw
White Wire
Ground Wire
Negative Wire
Black Wire
Outlet Box
Live Wire
Machine Screw
Decorative Nuts
Bulb(Not included)
ASSEMBLY INSTRUCTIONS
(English)
The light
sensor
L7006
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS
TOOLS & MATERIALS REQUIRED
·Screwdriver ·Wire Cutters
·Adjustable Wrench ·Wiring Supplies
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have
electrical wiring experience, refer to a do-it-yourself wiring handbook or have your fixture
installed by a qualified licensed electrician.
GENERAL
1． Be sure to read these instructions and review the diagrams thoroughly before
. beginning.
2． Electrical connections must be in accordance with local codes, ordinances, or the .
. National Electric Code. If you are unfamiliar with methods of installing electrical .
. wiring, secure the services of a qualified licensed electrician.
3． Before starting the installation, disconnect the power by turning off the circuit breaker
. or by removing appropriate fuse at fuse box. Turning the power off at the light switch
. is not sufficient to prevent electrical shock.
UNPACK THE FIXTURE
Check the contents of the wire connector. You should receive:
·Mounting Hardware Package
·Unassembled Fixture
PREPARE THE FIXTURE
NOTE: First turn off electricity.
1． If replacing an existing fixture, disconnect and remove old fixture. Expose the supply
. wiring from wire connector.
2． If your fixture is supplied with two machine screws, thread the long machine screws
. into the opposite side of the anchors. While supporting the fixture, make electrical
. connections.
FINAL ASSEMBLY
1． Spread electrical splices so Black wire are on one side of wire connector and White
. Wire on the other.
2． Install light bulbs (not provided) and cover assembly. Some models employ a twist off
. top cap to allow access to bulbs.
3． CAUTION: Refer to the relamping gtl label located near lamp holder for
. recommended maximum wattage. Do not exceed recommended wattage.
4． Use weather resistant caulk to seal around top and side perimeter of fixture back plate.
. Leave bottom uncaulked to allow for condensation and evaporation.
5． Restore electrical power.