User's Manual

FB155BC User Guide Version 2.1
10 Connecting the wireless section of Bluetooth
Page 16 / 2
10 Connecting the wireless section of Bluetooth
In order for Bluetooth devices to transmit data to each other, the wireless section of Bluetooth should be
connected to each other. To connect the wireless section, you should set each role for each device, one for a
MASTER, another for a SLAVE. It takes about 1~10 sec that a Master is connected to a Slave.
The connection can be done in use of AT command or connection can be set in use of connection WIZARD
because the initial connection mode of FB155BC is MODE4 (AT Command).
The following contents will be processed under the assumption that the FB755AC & FB755AS are connected
to the interface Board (Jig Board).
※ We will use 2 FB155BC and MS Windows in describing procedures.
10.1 Connecting with Connection WIZARD
※ The connection WIZARD can not be used if the DEBUG Char is set to 0x00. Please refer to the details
of environment setting in Appendix A for further details.
(1) Connect the interface board of the first FB155BC to the serial port of PC and switch ON.
(2) Execute C-Wizard Program.
<Figure 10-1 Connection Wizard Step 1>
(3) Click FIRMTECH SLAVE Set-up button (<Figure 10-1> Blue borders)