User's Manual

FZ200BS Manual VERSION 0.1.0
23
(6) If “OK” is output from FZ200BS, reboot FZ200BS by
inputting “ATZ”.
(7) “END START ERROR” is output at the moment when
FZ200BS is rebooted.
“END START OK” is output if the Zigbee Network is successfully
configured.
(8) Now, End Device of FZ200BS set-up is completed.
Turn the Power of the End Device OFF, and set other devices.
9-2-2. FZ200BS Router Set-up
(1) The initial set value of Device is ROUTER.
※ The initial set value of FZ200BS is ROUTER.
The following is a procedure of purposely setting Device to Router by using AT-Command.
However, Device originally operates as Router without intentional setting.
(2) FZ200BS device and the PC is connected and powered ON.
After running the HyperTerminal program, FZ200BS When you
reset the serial port "ROUTER START ERROR" is output.
“ROUTER START ERROR” means that the Zigbee Network
participation is failed.
“ROUTER START OK” is output if the Zigbee is successfully
configured Network.
(3) Input “+++” into Hyper Terminal.
(4) If “OK” is output from FZ200BS, AT-Command can be used
from then.
If “OK” is not output even after inputting “+++”, press “Enter”
key and input “+++” again, or reboot the device and input “+++”.
(5) Input “AT+SETROUTER” through Serial port of PC and press
“Enter” key.