User's Manual

FZ200BS Manual VERSION 0.1.0
25
“ATZ”, reboot FZ200BS.
(7) “COORD START OK” is output at the moment when FZ200BS is rebooted.
(8) Now, Coordinator of FZ200BS Set-up is completed, and the Zigbee Network is successfully
configured.
Turn the Power of the Coordinator Device OFF, and set other devices.
9-3. The Zigbee Network Configuration using FZ200BS
Try to configure the Zigbee Network after setting the Type for each Device.
9-3-1. The Zigbee Network configuration
Coordinator leads the Zigbee Network Configuration.
Coordinator manages the Zigbee Network.
(1) Coordinator to set up the device's power is ON.
After running HyperTerminal, FZ200BS will reset.
(2) “COORD START OK” and “TARGET NON” are output.
“TARGET NON” means that FZ200BS has yet to set its target
device.
(3) Zigbee Network is configured by Coordinator.
(4) From then, Zigbee Network Participation and Extension is possible by Router and End Device.
(5) Coordinator can transmit Data.
9-3-2. Zigbee Network Extension
Router performs the Zigbee Network Extension.
Communication distance and route can be extended because of the Zigbee Network Extension by
Router.
The number of End Device which participates in the Zigbee Network can be increased because of the
Zigbee Network Extension by Router.
Router also transmits data in the Zigbee Network, as well.
(1) Router to set up the device's power is ON. After running