User's Manual

FZ200BS Manual VERSION 0.1.0

(2) FZ200BS outputs a message “TARGET NON”, which means that its target device is not set.

(3) Input “+++” through Serial port of PC while FZ200BS

operates. “OK” is output. From then, its target device set-up is

possible with AT Command.

(4) After “OK” is output from FZ200BS “AT+SETTARGET

001551000000000B” through Serial of PC and press “Enter” Key.

AT+SETTARGET : It is a command to save the target device’s

address.

001551000000000B : It is the target device’s IEEE ADDRESS

(5) “OK” is output from FZ200BS which means that the command for saving target device is cognized.

If “ERROR” is output, the command inputted is wrong.

(6) Re-start FZ200BS by inputting a command “ATZ” or turn the power of FZ200BS off and on, again.

(7) FZ200BS is re-started and outputs a message “TARGET OK”.

(The target device must be power ON.)

Now, the target device set-up using its address is completed.

If “TARGET ERROR” is output, FZ200BS which has an IEEE

ADDRESS “001551000000000B” does not exist in the Zigbee Network or the address saved is wrong.

9-5. Serial Data Transmission

Data transmission is done in the Zigbee Network.

Data is transmitted to the target device “001551000000000B” that is set on the previous page.

IEEE ADDRESS of the Device(Router) which is supposed to transmit the data is 0015510000000005.