User's Manual

FZ200BS Manual VERSION 0.1.0
34
See if there is Router participated in the Zigbee Network configured by Coordinator.
See if there is Coordinator which has 8 child nodes.
See if there is Router which participates in the Zigbee Network and has 8 child nodes.
TARGET NON
: There is no IEEE ADDRESS of target device saved.
In this case, data transmission is not possible.
Set a target device to process data transmission.
TARGET OK
: Target Set-up is properly done by using an IEEE ADDRESS of target device.
Data transmission is possible.
TARGET ERROR
: Target Set-up using IEEE ADDRESS of target device is failed.
See if there is the target device in the Zigbee Network.
If there is the target device participated in the Zigbee network, check if the IEEE ADDRESS of
the target device is correctly saved.
OK
: The message “OK” is output from FZ200BS when a Device switches its mode from operation
mode to AT command mode.
- Use a command +++ to make the Device switches its mode from operation mode to AT
command mode.
The massage “OK” is also output when a Device switches its mode from AT command mode to
operation mode.
- Use a command “ATO” to make the Device switches its mode AT command mode to
operation mode.
10-5. RESET OPTION
(1) RESET OPTION
FZ200BS operates properly in the Zigbee Network.
Once the power of FZ200BS is turned ON, the device automatically participates in the Zigbee
Network. After the Zigbee Network Participation, the Device outputs “ROUTER START OK” or “END