User's Manual

FZ200BS Manual VERSION 0.1.0
8
(4) Coordinator and Router can configure child nodes up to 8
(5) End Devices cannot configure Child nodes
Setting FZ200BS to End Devices should be prior to the Zigbee Network Configuration. If you want to
change the device type of FZ200BS from Router to End Device in the Zigbee Network, you had
better re-configure the whole Zigbee Network in advance.
FZ200BS can configure Child nodes after they are set to Routers and participated in the Zigbee
Network. Also, other devices can participate in the Zigbee Network by setting the FZ200BS set to
Routers to their parent nodes, as well. If you change the FZ200BS set to parent nodes to End
Devices, the current End Devices cannot configure child nodes. In this situation, it is possibly can
happen that other devices set the Routers to their parent nodes before the Routers are changed to
End devices.
FZ200BS supports mesh network, so you can expect the stable Zigbee Network. However, in order
to make sure of proper Zigbee Network configuration, FZ200BS of child nodes had better save
FZ200BSs set to Router (or coordinator) as their parent nodes.
Thus, you had better set the type of each Device (especially End Device) before the Zigbee Network
Configuration.