Installation Guide

Batteries and Emergency Override Keys
Remove four AA batteries and two Emergency Override Keys. They are
located in the protective Styrofoam insert at the top of the box.
2
Opening Safe For The First Time
9
Home and Office Security Safes
Important: FIRST TIME ACTIVATION
Your safe is ready for activation. To allow the safe to be opened and to prevent
locking of the safe prior to completing the first-time user activation procedures, a
solenoid deactivation safety device has been installed.
Important: ENABLE/DISABLE SOUND
Once the batteries are installed, if you do not hear a beep when entering the
factory pre-set Passcode or during the personal Passcode re-programming process,
enter the following key sequence into the digital keypad: #
*
# This will turn
the sound on. Repeat the process if you want the sound turned off.
User Activation
Install Batteries
1. Turn handle upwards to the right and pull open the safe door.
2. Slide the battery compartment cover (located inside the
safe at the top of the door) forward and remove. Install
the four AA batteries. Make sure the batteries are installed
in the proper direction as indicated in the battery
compartment. Slide the cover back into place.
3. After the batteries are correctly installed, the red and green
lights located at the top of the keypad on the front of the safe
will blink twice, the keypad backlight will flash once and
you will hear a single beep.
4. Proceed to Activate Lock.
Activate Lock
1. Locate the small plastic Locking Pin on the inside of the
safe door. Grip and pull out completely. Pin can then be
properly discarded.
2. Leave the safe door open and proceed to Electronic
Locking System Test.
+
-
+
-
RED
LIGHT
GREEN
LIGHT
Consumer Affairs
Your Safe’s Unique Identification Numbers
When contacting Consumer Affairs, you should be prepared to supply some
important information that specifically identifies your safe. This information is
extremely important to assuring prompt and accurate customer assistance.
It is strongly recommended that you identify and record the following information in
the Safe Identification Record form located on the inside back cover of this manual:
Model Number
Serial Number
Key Number
Locating Model and Serial Numbers
Most First Alert
®
safes include a small metallic silver or gray tag affixed to one of
the surfaces. This tag is usually located on the front or right side of the safe. This
tag contains the Serial Number, and on selected models a similar tag is attached
containing the Model Number. If a Model Number tag is not attached to the
safe, then it can be located on the front or side panel of the box that the safe was
packaged in. Write this number down for future reference.
Key Number
The Key Number is located on the key. If you do not have the key, the number is
also located on a sticker on the inside of the Emergency Override Key lock cover.
Important: DO NOT REMOVE TAGS!
In case your safe becomes inoperable or you lose your keys, these identification
numbers will be needed to correct the problem. It is recommended that the
number tags remain in place on the safe. If removal is necessary, then they should
be attached to the inside back cover of the Operation and Installation Guide.
Store in a safe and secure place for future reference.