Installation Guide

Home and Office Security Safes
74
Test Locking System
Testing the Passcode
1. With the safe door open and the Live Bolts engaged, you can
now test the Electronic Locking System using the pre-set three
digit factory code. Locate the digital keypad on the front of the
safe and open up the protective cover to expose the keypad.
2. When the cover is opened, the keypad is activated and the
keypad backlight will turn on and remain on for approximately
five seconds. When the backlight turns off, the keypad is still
active and the backlight will turn on again when any key is
pressed.
3. The pre-set three digit factory Passcode is 159. Enter this
Passcode as follows:
Note: All entries are accompanied by a beep and the green light will
flash.
4. After properly entering the entire sequence, the green light will
turn on and the lock will click. You now have five seconds to
open the safe by turning the safe door handle upward to the
right.
Important: IF HANDLE WILL NOT TURN
If the handle will not turn to the right after the green light comes on, first turn
the handle slightly back to the left until it stops, then turn upwards to the right
again to open.
5. Once the handle has been turned to the right, the Live Bolts will
disengage and retract into the door. You have successfully unlocked the
safe and the door is now in the unlocked position.
6. Leave the safe door open and proceed to Programming a Personal Passcode.
Important: SECURITY LOCKOUT PERIODS
For added security, the safe will automatically lock out entry for 15 minutes
after three attempts to open with an invalid Passcode.
Additional Features
Shelves
To allow for greater flexibility and further accommodate your particular storage
needs, this safe includes (one) Adjustable/Removable Shelf.
1. Position shelf so that the gripping ridges are on the top and towards the front
of the safe.
2. Locate the approximate position in the safe where you would like to place the
shelf and, using the guides molded into the walls of the safe, slide into place.
Low Battery Indicator
Every time the keypad is activated, the system automatically checks the power
level remaining in the batteries. If the power falls below a certain level, the red
light will flash every two seconds to indicate the need for new batteries. See page
six for instructions on replacing the batteries.
Disable / Enable Sound
1. To Enable (Turn on) the sound during normal operation, press the following
key sequence:
2. Repeat the process to turn the sound off.
Removable File Rack
For your convenience, this safe also includes (one) pre-installed Removable File Rack.
If you would like to remove or re-position the File Rack, simply grasp it on both sides,
pull forward, and lift it up and out of the safe. To re-install the File Rack, locate the
approximate position in the safe where you would like to place it and, using the
guides molded into the walls of the safe, slide into place.