User's Manual

Page 32
REMOTE ACCESS
V SHOW
VSS Software
Introduction
The VSS software allows both local network and worldwide access to your DVR
Installation
Microsoft Internet Explorer version 8,9 or 10 is required is to dial into the DVR.
The DVR must also be connected to a network with Internet access.
1. Retrieve the DVR IP address (See page 20)
2. Open Internet Explorer
3. Type the DVR IP Address into the address bar, and press enter, also
add the HTTP port (i.e., http://192.168.1.182:10812)
4. Default Login is username “admin” and password is blank
After logging in, Active X will install (if not already installed) and
installation will proceed
Click “Install”, then re-launch the browser
After Active-X has been installed, you can login using the default
username and password.
Press “Exit” to quit at any time
Note: If you are using Internet Explorer 9.0 and encounter an error, it may be a compatibility problem. To correct, go to the “Tools”
menu in Internet Explorer, and select “Compatibility View Settings”, and select the “Display all websites in Compatibility View”
option. Press “Close” and refresh the screen
Main Interface
Log In
After launching the VShow
software, the log in screen will
open. The default password
and username are “super.”
After login, the password
can be modified the by
entering the settings menu.
Using the VShow
software
After you are logged in, the main
DVR interface will launch (see
image below)
Certain settings can be adjusted
by selecting menus to the right
of the camera display area. The
menus are:
1. Channel
Channel Selection
Select channel
2. Function Key
Local playback: playback local
recording
Open all: play live video in view
3. Surveillance window
Change window layout
4. Image color
Image color: modify brightness, contrast, saturation and hue
Other: set capture path, recording download path and reboot
5. PTZ Control
Control PTZ devices
6. Menu
System configuration, recording search, alarm settings, exit
4
5
2
6
1
3