User's Manual

Page 49
Monitor Project
The operations in monitor project include task and plan config;
pause and resume project; import and export; run and stop
tasks.
Task Configuration
“Task” is the sub item of “Save” in screen contact menu.
To add a new task, first input the task title and select the
screen number (1,4,6,8,9,13,16,20,25,36), then select the node
or device and add it into the task sub-item by clicking save to
complete the operation.
All the channel information is listed in the task sub-item, like
the device, channel, camera ID, stop duration (10-3600s),
preset (1-128) and stream.
1. New: add a new task
2. Modify: modify the task configuration
3. Stay time: the default is 20 seconds. Double left click to
modify the time between 10-3600 seconds.
4. Preset: double left click to add preset number
5. Save: save the configuration
6. Cancel: cancel the select item
7. Exit: quit this window
Note:
1. there are maximum 100 devices in one task
2. select a node to add all devices in this node into the task
3. modity one stay time and apply this time to all in context
menu
Plan Configuration
Click “Add” and modify the plan parameter like title, task start/
end time. You can put the exist tasks into the plan.
Add several tasks into one plan, set the start and end time to
make a cycle execution.
Modify: modify the plan configuration
Delete: delete a plan
Exit: quit this window
There are a maximum of 100 tasks in one plan. In the monitor
project interface, click the task to carry it out.
Pause: pause and resume the running project
Import: import tasks and plans list
Export: export tasks and plans list Introduction: the monitor
project configuration is keep in local. Copy the configurations
between devices by import and export data.
EMap
EMap is used for showing the alarm and device locations. The
photo to the right shows the EMap interface
Upper left: Organize structure
Left bottom: Channel feed
Right: Map
There are camera icons, alarm icons and the next level map
icons on the map window.
Double left click the next level map icon to turn to that map.
Single click the camera in organize structure to get the camera
location on map. Double left click the camera in list or on map
to play the live view in left buttom screen.
Double left click the screen to turn to the full screen mode;
double left click again or press “ESC” to quit.
“PTZ Control” : control the camera motion
“Talk” : talk through channel device
“Send” : send the video to playback window
“Stop” : stop the video playing : minimize the map : full screen
the map.
Note: zoom in/out with mouse scroll wheel
REMOTE ACCESS
IMS200