Printer User Manual

Using Single-sheet Paper
Reloading during printing
When you print a document more than one page long using single-sheet
paper, there are two ways your software can enable you to load a new
sheet at the end of a page:
l If your software sends characters in a continuous stream, the printer
stops printing when it reaches the bottom of the paper. When this
happens, the ON LINE light goes off automatically.
l If your software handles printing page by page, it probably stops
sending characters at the end of a page and prompts you to insert
more paper’. In this case, the ON LINE light may remain on. If it does,
the first thing you should do is press the ON/OFF LINE button once to
turn it off.
Once the ON LINE light is off, remove the sheet that has just been printed
and load a new sheet in the same way as before.
Printing multi-part forms and copies
If you wish to print multi-part forms or carbon copies, use no more than
three sheets or parts at a time, with a total thickness of no more than
0.01 inches. The factory setting for the paper thickness lever, located
inside the front lid on the left side, accommodates both single sheets and
multiple forms. There is no need to adjust the lever.
Setting Up 1-21