Use and Care Manual

Safety Data Sheet
Procduct: SDS No: 06-1753AFA 101X
SECTION 1 : GENERAL INFORMATION
PIEDMONT CHEMICAL INDUSTRIES I, LLC
331 BURTON STREET
HIGH POINT, NC 27261
Telephone [phone]
In cas of emergency call chemtrec: 1-800-424-9300
Outside of U.S.A.: 001-703-527-3887
Date: 4/10/2015
SECTION 2 : HAZARD(S) IDENTIFICATION
Signal Word: Warning
CHS - Classification
Eye Damage/Irritation (Category 2A)
Hazard Statement(s)
H319 Causes serious eye irritation
Precautionary Statement(s)
P264 Wash hands thoroughly after handling.
P280 Wear protective gloves/eye protection/protective clothing.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for 15 minutes or more. Remove contact lenses, if present and easy to do. Continue rinsing.
P337 + P313 If eye irritation persists: Get medical attention
P501 Dispose of contents in container in accordance with local/state/federal/international regulations.
SECTION 3 : COMPOSITION/ INFORMATION ON INGREDIENTS
HAZARDOUS INGREDIENT CAS# PERCENTAGE
SPECIFIC CHEMICAL NAME(S) AND CAS NUMBER(S) MAY BE A TRADE SECRET AS ALLOWED BY 29 CFR 1910.1200
SECTION 4 : FIRST AID MEASURES
EYES:FLUSH EYES WITH WATER FOR AT LEAST 15 MINUTES.IF IRRITATION OCCURS, GET MEDICAL ATTENTION.
SKIN:WASH EXPOSED AREAS WITH SOAP AND WATER. IF IRRITATION PERSIST, SEEK MEDICAL ATTENTION.
INGESTION:DO NOT INDUCE VOMITING. GIVE LARGE QUANTITIES OF WATER TO DILUTE. KEEP PATIENT WARM AND QUIET AND GET
IMMEDIATE MEDICAL ATTENTION.
INHALATION:IF AFFECTED, REMOVE INDIVIDUAL TO FRESH AIR.
SECTION 5 : FIRE FIGHTING MEASURES
FLASH POINT:N.A.
EXTINGUISHING METHOD:NO SPECIAL REQUIREMENTS.
SPECIAL FIRE FIGHTING PROCEDURES:USE SELF-CONTAINED BREATHING APPARATUS WITH FULL FACESHIELD.
UNUSUAL FIRE FIGHTING PROCEDURES:NONE KNOWN.
SECTION 6 : ACCIDENTIAL RELEASE MEASURES
PERSONAL PRECAUTIONS:Ensure adequate ventilation. Keep people away from and upwind of spill/leak.
ENVIRONMENTAL PRECAUTIONS:Avoid subsoil penetration. Do not flush into surface water or sanitary sewer system. Advise water authority if spillage has
entered water course or drainage system.
METHODS FOR CLEAN UP:Use mechanical handling equipment. Soak up with inert absorbent material( e.g. sand, silica gel, acid binder, universal binder,
sawdust)
SPILL:VENTILATE AREA, PERSONS PERFORMING CLEAN-UP SHOULD WEAR ADEQUATE PROTECTION EQUIPMENT. CONTAIN MATERIAL BY
DIKING THE AREA AROUND THE SPILL. IF THE PRODUCT IS IN A SOLID FORM, SHOVEL DIRECTLY INTO RECOVERY DRUMS. IF THE
PRODUCT IS A LIQUID, IT SHOULD BE PICKED UP USING A SUITABLE ABSORBANT MATERIAL, THEN SHOVELED TO RECOVERY
DRUMS. IF THE MATERIAL IS RELEASED INTO THE ENVIRONMENT, THE USER SHOULD DETERMINE WHETHER THE SPILL SHOULD BE
REPORTED TO THE APPROPRIATE LOCAL, STATE AND FEDERAL AUTHORITIES.
SECTION 7 : HANDLING AND STORAGE
HANDLING AND STORAGE:MATERIAL SHOULD BE STORED IN ITS OWN CONTAINER AND SHOULD ALWAYS BE KEPT COVERED WHEN NOT
IN USE.
SECTION 8 : EXPOSURE CONTROLS AND PERSONAL PROTECTION
ROUTES OF EXPOSURE:EYES, SKIN, INGESTION, INHALATION
SYMPTOMS OR ACUTE HEALTH HAZARDS
EYES:CAUSES REDNESS, TEARING, IRRITATION. OVEREXPOSURE MAY CAUSE CHEMICAL BURNS.
Page 1 of 3 ND = NOT DETERMINED NA = NOT APPLICABLE
www.piedmontchemical.com Rev. 2.0