Use and Care Manual

Page 31
RECORDING AND CAPTURE SETTINGS
Check the storage mode of the HDD: Menu > HDD > General.
1. Click Advanced
2. If HDD mode is Quota: Set maximum record capacity and
maximum picture capacity. If HDD mode is Group: Set the
HDD group.
Configure parameters to define image quality including
transmission stream type and resolution. Enter the Record
Settings interface to set recording parameters:
Menu > Record > Parameters > Record.
1. Configure parameters according to table below.
2. Click Apply.
Configuring Parameters
To set sub-stream parameters, enter sub-stream tab page.
1. Use the dropdown lists to set each parameter.
2. Click Apply.
Before you start
Make sure the HDD has already
been installed and initialized.
To set parameters for capture, click Capture.
1. Use the dropdown lists to set each parameter.
2. Click Apply.
Setting Function
Pre-Record Time set to record before a scheduled event
Post-Record Time set to record after a scheduled time or event
Expired Time
The longest time for a record file to be kept in the HDD
before deleting. “0” will keep a file from being deleted.
Redundant Record / Capture Enable to save record and captured picture in redundant HDD
Record Audio Enable / Disable audio recording
Video Stream
Choose between main stream or sub-stream (Sub-stream
allows longer record time with the same storage space)
NOTE
:
The interval is the time period between two capturing
actions. You can configure all the parameters on this
menu on your demand.
NOTE
:
Redundant HDD must be
configured in HDD settings
prior to use.
NOTE
:
Main stream parameters
are read-only.