Use and Care Manual

Page 87

Upgrading by FTP

Enter the Upgrade interface: Menu > Maintenance > Upgrade > FTP.

Enter the FTP Server Address and click Upgrade.

NOTE

NVR must be rebooted after upgrade to activate new ﬁrmware.

Before you start

Conﬁgure PC and NVR to same

Local Area Network before starting.

Run the third-party software on the

PC and copy ﬁrmware into the root

directory of FTP.

Restore Default Settings

Enter the Default interface: Menu > Maintenance > Default. Click OK.

NOTE

All NVR parameters will revert to the default settings

excluding the network parameters: IP address,

subnet mask, gateway, MTU, NIC working mode,

default route, and server port.

MANAGEMENT AND MAINTENANCE