Use and Care Manual

Page 55
Hot Spare Device Backup
BACKUP
Setting Hot Spare Device
Enter the Hot Spare Settings interface:
Menu > Configuration > Hot Spare.
1. Set the Work Mode as Hot Spare.
2. Click Apply.
3. Click Yes to reboot device.
Before you start
At least two devices must be online. A bidirectional
connection is required to be built between the hot
spare device and each working device.
Set a hot spare
device
Add a hot spare
device on normal
device
Add the normal
device on the hot
spare device
Start Finish
Setting Working Device
Enter the Hot Spare Settings interface:
Menu > Configuration > Hot Spare.
1. Set the Work Mode as Normal (default).
2. Check Enable.
3. Enter IP address and admin password of hot spare device.
4. Click Apply.
NOTE
:
The camera connection will be disabled
when the device works in hot spare mode.
It’s highly recommended to restore the
defaults of the device after switching the
working mode of the hot spare device
to normal mode to ensure the normal
operation afterwards.