Use and Care Manual

Page 69
NETWORK SETTING
Checking Network Traffic
To check network traffic and real-time information of
the NVR, access the Network Traffice interface: Menu >
Maintenance > Net Detect.
NOTE
:
Traffic data is refreshed every one second.
Telnet Settings
The Telnet function provides easy access to the NVR.
Enter the Advanced settings interface: Configuration >
Remote Configuration > Network Settings > Advanced.
1. Check Enable Telnet.
2. Click Save.
3. Open the Command Prompt window on the PC, and
input “telnet IP Address” to connect with the NVR.
Configuring Network Detection
Testing Network Delay and Packet Loss
Enter the Network Traffic interface: Menu > Maintenance >
Net Detect > Network Detection.
1. Enter Destination Address.
.
2. Click Test.
NOTE
:
Clicking Test will display one of the following messages.
For example, if the IP address of the NVR is 192.0.0.64, you
can input “telnet 192.0.0.64” and then press Enter to connect.