Digital Camera User Manual

3
Setting Up Your
P-500 Camera
GENERAL PRECAUTIONS
 Use only the power supply provided with the system.
 Unplug the power supply when the system is not in use for extended periods.
 Do not place any of the equipment near a radiator, vent, or other place where it
might be exposed to heat, moisture, dust, vibrations, or strong magnetic fields.
 Do not attempt to repair the camera. Contact a qualified technician or the dealer for
service. Any change or modification may damage the equipment and invalidate the
warranty.
 When installing the camera, follow manufacturer’s advice when using power tools,
steps, ladders, etc. and wear suitable protective equipment (e.g., safety goggles)
when drilling holes. Before drilling holes through a ceiling, check for hidden
electricity cables and water pipes.
INSTALLING THE CAMERA
1
Remove cover from camera lens. Select the position for the camera and secure the
camera stand.
Screws and anchors are supplied. Use an appropriate screw type for the mounting surface.
2 Adjust camera to the proper view angle. Make sure the lens is upright relative to your
subject. Tighten the set screws.
3 Connect the camera to power using the supplied power cable and adapter.
camera stand
camera lens
set screw