Use and Care Guide

(a)
(b)
Fire -Fighting measures
(c.) Speclized Equipment
(a)
Personal protection
(b)
Released or spilled contents:
Clean up
(a)
Handling
(b)
Storage
Handling and storage:
(a)
Exposure Limits Extinguisher:
Exposure Limits contents:
Carcinogen potential:
(b) Engineering Controls N / A
(c.)
Personal Protection;
Eye protection:
Hand and skin protection:
Respiratory protection:
Appearance and odor: Fine, odorless powder, either a pale YELLOW or PINK in color,
pH: Relative Density; NA NA
Boiling point, °C : N / A Water Soluble Slight NA
Oxidizing properties: Not an Oxidizer Fat Soluble NA
Vapor pressure, mm Hg: N / A Evaporation rate (Butyl acetate=1) NA NA
Color None, GAS
Flash point:
Flammability ( solid / gas )
Auto-ignition temperature: NA DOES NOT IGNITE
Explosive hazards:
Extinguishing media:
Unusual fire and explosion hazards:
(a)
Chemical Stability:
(b)
Conditions to avoid:
(c.)
Incompatibility :
(d)
Materials to avoid
(e.)
Hazardous decomposition products
(f)
(a)
Toxicology
(b)
(c.)
Contents are treated as a nuisance dust. For specifics see content manufactures SDS.
See section 3 or Product label
Extreme heat
Do not mix with BC type dry chemical extinguishing agents or other fire extingushing
agents.
Strong acids, Na and K alloys, ABC dry chemical agents,NH
4
H
2
PO
4
.
NORMALLY STABLE. Hazardous polymerization will NOT occur. Combustion or
decomposition products include carbon dioxides.
SECTION 11 - TOXICOLOGY INFORMATION
None when used in accordance with instruction manual.
N / A - The product is a FIRE EXTINGUISHER with extinguishing agent within.
None when used in accordance with instruction manual.
SECTION 10 - STABILITY AND REACTIVITY
Stable
Not Soluble
Vapor density (Air=1):
Evaporative rate:
Oder Oderless
N / A - The product is a FIRE EXTINGUISHER with extinguishing agent within.
N / A - The product is a FIRE EXTINGUISHER with extinguishing agent within.
Use safety glasses with side shields or safety goggles.
None normally needed. Use chemical resistant gloves when handling for prolonged
periods of time. The agent will dry the skin.
Dust mask where dustiness is prevalent, or TLV is exceeded. Use mechanical filter
respirator if exposure is prolonged.
SECTION 9 - PHYSICAL AND CHEMICAL CHARACTERISTICS OF DRY CHEMICAL AGENT WITHIN FIRE
Viscosity;
Melting point, C:
Follow the temperature limits specified on the label but no other special conditions are
required for safe storage.
Follow instructions specified in the instruction manual.
SECTION 8 - EXPOSURE CONTROLS/PERSONAL PROTECTION
Follow temperature limits on label.
Nuisance dust limits; OSHA TWA; 15mg/m³; ACGIH TLV-TWA: 10 mg/m³
Extinguishing agent within the extinguisher has not been listed as a carcinogen by National
Toxicology Program, IARC, or OSHA.
SECTION 6 - ACCIDENTAL RELEASE MEASURE OF DRY CHEMICAL
See Section 8. If applicable remove yourself from area until nuisance dust settles.
Material maybe swept up and stored in a covered container for disposal, see section 13. In
keeping with best practices do not mix with other materials. Agent can not be reused.
See Section 13. Sweep up material and dispose in sealed container.
SECTION 7 - HANDLING AND STORAGE
Extinguishers are heavy and care should be taken in handling to minimize the possibility of
accidental dropping. See personal protection in section 8.
SECTION 5 - FIRE FIGHTING MEASURES
This product is a Fire Extinguisher and is not flammable.
The product is a Fire Extinguisher and will not burn. No special protective equipment is
needed for fire-fighters. Wear protective equipment appropriate for fire conditions. In an
Standard protective equipment recommended