Use & Care Guide

E-3
• Remove the battery insulator tabs by pulling them out of the battery
compartments on the transmitter and receivers before first use.
Note : Remove and reinstall the batteries if there is no response after pulling out
the insulation tab.
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to
death.
Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
BATTERY WARNING
1. Be sure that the batteries are installed correctly. Wrong polarity may damage
the unit
2. Use only the size and type of batteries specified.
3. Do not mix old and new batteries.
4. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and may
void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer’s directions)
6. Do not dispose of batteries in fire, batteries may leak or explode.
PAIRING THE TRANSMITTER WITH THE RECEIVERS
1. The transmitter will automatically turn ON when you remove the battery
insulator tab from the battery compartment on the transmitter.
2. Remove the battery insulator tabs from the receivers.
3. Slide the receiver ON/OFF SWITCH (#5) to the ON position.
4. The LED INDICATOR (#3) on the receiver will flash and a beeping sound will
start. The receiver is now ready for pairing with the transmitter.
5. Press the COLOR CODED BUTTON (#2) on the transmitter that matches the
COLOR CODED MARKING (#4) on the receiver that is beeping.
6. The beep sound will stop and the transmitter is now paired with that receiver.
7. Repeat steps 3 to 6 to pair the other 3 receivers.
Note :
• Make sure the transmitter and receiver are close to each other when pairing.
• If the pairing fails, the beep sound will continue and will not stop.