Indoor Motion Sensor LED Lights SFA265 USER MANUAL PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE
COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
POWER SOURCES Each SFA265 light operates using 3 AAA (UM4) batteries (not included). BATTERY OPERATION 1. Remove the BATTERY DOOR (#3) on the back of the SFA265. 2. Insert three new AAA(UM4) batteries (not included). Make sure the positive and negative ends of the batteries are inserted properly. Replace the BATTERY DOOR (#3). Note: For best performance and longer operating time, we recommend using alkaline battery. BATTERY WARNING 1. Be sure that the batteries are installed correctly.
OPERATION ON Mode: Slide the FUNCTION SWITCH (#4) to ON. The LED LIGHTS (#2) turn on, and will remain on. AUTO Mode: Slide the FUNCTION SWITCH (#4) to AUTO. When placed or mounted in a dark area, the LED LIGHTS (#2) will automatically turn on if motion is detected or if a person approaches the SENSOR (#1). If no motion is detected, the LED LIGHTS (#2) will automatically turn off after 25 seconds. OFF Mode: Slide the FUNCTION SWITCH (#4) to OFF. The LED LIGHTS (#2) will turn off.
charges will be at SPECTRA’s expense. There are no other express warranties other than those stated herein. This warranty is valid only in accordance with the conditions set forth below: 1. The warranty applies to the SPECTRA product only while: a. It remains in the possession of the original purchaser and proof of purchase is demonstrated b.
