Use and Care Manual

E-2
POWER SOURCES
Each SFA265 light operates using 3 AAA (UM4) batteries (not included).
BATTERY OPERATION
1. Remove the BATTERY DOOR (#3) on the back of the SFA265.
2. Insert three new AAA(UM4) batteries (not included). Make sure the positive
and negative ends of the batteries are inserted properly. Replace the
BATTERY DOOR (#3).
Note: For best performance and longer operating time, we recommend using
alkaline battery.
BATTERY WARNING
1. Be sure that the batteries are installed correctly. Wrong polarity may damage
the unit.
2. Use only the size and type of battery specified.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
5. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and may void
the warranty.
6. Do not try to recharge any batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer’s directions).
7. Do not dispose of batteries in fire, batteries may leak or explode.
INSTALLATION
Note: Use alcohol to clean the surface of all mounting areas thoroughly and then
dry with a lint-free cloth prior to attaching the double-sided tape.
1. Locate an area for mounting the Motion Sensor LED lights.
2. Peel away the backing from the double-sided tape and attach
the double-sided tape onto the back side of MOUNTING
BRACKET (#5).
3. Peel away the backing from the double-sided tape mounted on
the MOUNTING BRACKET (#5), and firmly press it onto the
surface you wish to mount to.
4. Place the SFA265 on the MOUNTING BRACKET (#5).
Note:
You can also mount the SFA265 by using mounting screws
(not included). Use the MOUNTING BRACKET (#5) as a
template to mark the position of the drill holes on the wall.