Heart Rate Kit Installation

Kit includes the following parts:
- HR Receiver 5.0KHz
- Mid line wire with leads
- Wire-holding placement pads and plastic ties (1x)
Heart Rate Kit Installation Instructions:
Pacific / Newport AR Rower
1 After confirming all parts are present, Stand the Pacific Rower into the vertical position and
attach the 100mm lead to the lead on Mainframe here
2 Mount the Receiver exactly as shown 
3 Connect the Receiver lead to the 100mm lead and secure wire into position.
Note: Don’t affix permanently until signal in this location is tested. Mount the Receiver low
enough to avoid the lower Seat Rollers. Trim excess.
To display heart rate requires a First Degree Fitness long range strap (sold separately) Polar ™ or oth-
er compatible brand chest strap transmitter available from your dealer.
Notes: Maintaining a consistent signal on a rower can be a challenge due to the varying distances
experienced during the rowing stroke between the Receiver/Transmitter.
If you are experiencing difficulty, make sure the batteries on your chest belt or other device are fresh,
and that the frequency of your transmitter is 5KHz.
Environmental conditions, as well as proximity to other machines can also interfere with a clean signal.
Feel free to experiment with different locations for best performance.
1
3
2