Operation Manual

Reattaching the Rower Belt

STEP 1

STEP 2

Velcro Facing Upward

Begin reattaching the Rower Belt by threading

around the Rower Belt Pulley with the Velcro side

facing upward as illustrated.

Idle Wheel

Next, thread the Belt around the Idle Wheel as

shown. Once around the Idle Wheel, attach the

Rower Belt to the Belt/Bungee Pulley. There is

an obvious “lip” at the attachment point.

Rower Handle

Belt/Bungee Pulley

STEP 3

STEP 4

STEP 5

Wind the Rower Belt onto the Belt/Bungee Pulley

until the Rower Handle is as it’s furthest forward

position.

Bungee Shock Cord

Bungee Pulley

Rethread the Bungee Shock Cord (on opposite

side of the Idle Wheel) back through the Bungee

Pulleys and tie off at the Attachment Point.

Recoil tension will decrease over time as the Bungee Shock Cord

stretches. To increase recoil tension, simply push the Inner Clip

out of the Bungee Hook from behind, pull the required amount of

bungee through the Inner Clip and replace the Inner Clip into the

Bungee Hook as shown below.

Hint: Before reattaching the Inner Clip/

Bungee Hook, tie a slip knot under slight

tension at the lower bungee pulley. This

will keep the bungee under tension while

reassembling the Bungee Hook.

Bungee Hook

Inner Clip