Operation Manual

Bungee Cord Replacement. Dealer Assistance Required

(Expect 2-5 years bungee life in commercial use. Damage during initial rower

assembly is not covered under warranty)

1. Unhook Bungee Cord Hook. Remove

computer mount with 6mm Allen key.

2. Carefully peel back and remove the

Belt Pulley Sticker. Then remove

C-Clip and Black Spacer as shown.

Pulley Sticker

Spacer

C-Clip

Spacer

3. Remove the Belt Pulley and the Spacer.

Unhook the Bungee Cord End from the

Pulley and remove by pulling out from

the bottom.

Ear Strap

4. Feed the new Bungee Cord from

below and reattach end strap to the

Belt Pulley.

5. Attach the Spacer to the end of the

rower pulley and use the “ear” to help

thread the strap into the machine.

Note that the Spacer may require

being tilted just slightly to allow it to

pass through.

Tilt Spacer

slightly

6. Reattach the Bungee Hook to the end

of the Seat Rail, install outer Spacer,

C-Clip and Sticker. Test for proper

installation. If the C-Clip cannot be

reinstalled, then remove Pulley and

try again as the Strap may be

jammed.

Note: A light tap may be required if the black inner Spacer will not pass inside the frame.

A tight C-Clip mounting indicates the process should be repeated as the belt is jammed up.

Ear