User's Manual

Getting Started 2

After the test, the screen will also display a message "press <F2> to enter

SETUP". You don’t need to run this program at the moment as your dealer

already made the necessary settings for your Mini-note optimal operation.

Refer to Chapter 6 on running the SETUP program later.

After the test has completed, your Mini-note will start to search and boot up

the operating system from your hard drive. The Mini-note normally comes

with a Windows operating system pre-installed in your hard drive. Consult the

Windows manual on how to use the program. If not, contact your dealer for

assistance.

2.4 Adjusting the Display Controls

The LCD brightness adjustment is controlled by <Fn> +<F8> and <Fn> +

<F9> keys respectively. You need to press these hot-key controls after

powering on your Mini-note to suit your viewing pleasure.

The Brightness hot-key control adjusts the brightness on the LCD. The

brightness hot-key control will not set the LCD completely dark or bright; it

provides sufficient lighting to the LCD to match the external lighting of the

surrounding. The brighter the room, the more you need to increase the

brightness of the LCD.

2.5 Device Drivers Installation

If you already have an operating system installed into your Mini-note, it is best

to install the needed device drivers for using the built-in devices of your Mini-

note. Before installing the drivers, check with your dealer first if they have

already installed all the drivers along with the operating system. If not, follow

the procedures below: