User Manual

Using Your Notebook 3

101

The 4 in 1 card slot is used by the following cards as SD, MS (Memory Stick ),

MMC, and MS_Pro.



For a single moment, only one card can be inserted into the 4 in 1 card slot

Inserting Flash Memory Card

To insert a flash memory card into the slot is similar to ExpressCard. You only

need to pay more attention whenever insert the flash memory card into the slot

with the correct side.

For MMC and SD card, you should position the copper connector at the

bottom side. For Memory Stick card, you should position the copper

connector at the topside. All of these cards should be located at the center of

the slots in inserting.

Slot Card type Copper connector

4 in 1 SD (Secure Digital)

MMC (MultiMedia Card)

MS (Memory Stick)

MS_Pro

Bottom side

Bottom

Top side

Only one correct side can be accepted for the 4 in 1 card slots. If you cannot

insert the card into the 4 in 1 slot or you had inserted the card but it is not

recognized by the computer, please remove the card and turn the card upside

down and insert it again. To prevent the damage made both on card and the

slot, never forced an entry into the slot with incorrect side.