™ FSC OWNERS MANUAL
TABLE OF CONTENTS Warnings.....................................................................................................................................................................................................3 Quick Start Guide.......................................................................................................................................................................................4 FSC Diagram.........................................................................
QUICK START GUIDE FSC DIAGRAM Thank you for purchasing the First Strike FSC Pistol. Like any paintball marker, it is important that safety is on the forefront of your mind at all times when using this product. Never operate the FSC without ASTM compliant goggles or aim at anyone that is not wearing proper goggles intended for the game of Paintball.
FSC MAGAZINE DIAGRAM OPERATIONAL INSTRUCTIONS GETTING STARTED PROJECTILE RETAINER PIN Read this entire manual before using this launcher. Keep your launcher pointed in a safe direction at all times. 1. SAFETY - Place the FSC™ in safe mode by pushing the safety button so no red is visible. * Visible red indicates that launcher will discharge. PROJECTILE FOLLOWER TRACK 2.
OPERATIONAL INSTRUCTIONS 4. LOAD PROJECTILES - Insert a maximum of 6 projectiles into the magazine from the top (Diagram 1). The projectiles will be held in place automatically by the projectile retainer pin. You can also lock the Projectile Follower in the down position by pulling down on the Projectile Follower ears. FSR projectiles must be oriented as shown in the illustration. (Diagram 2) OPERATIONAL INSTRUCTIONS 8. LOAD MAGAZINE - Place the magazine in the grip of the FSC™ as illustrated below.
FSC CLEANING & MAINTENANCE CLEANING • Never perform maintenance on a loaded or pressurized FSC Pistol • Remove all projectiles from the magazine and marker prior to doing any cleaning or maintenance. Never use petroleum based cleaning solvents or lubricants. • Do not use cleaning solvents that come in aerosol cans. • To clean the FSC Pistol, remove the barrel as described in the “Operational Instructions”. Use a .
GUN BODY ASSEMBLY ITEM NO. 1 2 3 4 5 NAME ITEM NO. Upper Assembly Firing Bolt Spring Barrel Lower Assembly Rubber Nubbin 6 7 8 9 UPPER ASSEMBLY NAME ITEM NO. #8-32 X 1/2” 18-8 Stainless St Flat Head, 8-32X3/4 Soc. Flat Hd, 6-32 X 0.25 Magazine 1 2 3 4 5 6 7 8 9 3 5 NAME ITEM NO. Regulator Pistol Body Ammo Relese Fork Firing Bolt Assembly Gun Body Cap Barrel Lock Front Sight Rear Sight Trigger NAME 10 11 SHCS #4-40x.3125 Reg.
LOWER ASSEMBLY ITEM NO. 1 2 3 4 NAME ITEM NO. Upper Frame Handle Assembly Safety O-Ring, Red Safety 5 6 7 FIRING BOLT ASSEMBLY NAME ITEM NO. Mag Release Spring #8-32 X 3/8” 18-8 Stainless St Bhcs 8-32X0.375 Black Ox 1 2 3 4 5 NAME ITEM NO. Air Chamber Plug Air Chamber Plug O-Ring Air Chamber Air Chamber Shock Absorber Air Chamber Cap O-Ring 6 7 8 9 NAME Air Chamber-Od O-Ring First Strike Firing Bolt Fs Firing Pin- 8.
MAGAZINE ASSEMBLY ITEM NO. NAME ITEM NO. 1 2 3 4 5 6 7 8 9 10 11 Main Magazine Body-L Main Magazine Body-R CO2 Valve Body CO2 Drum Valve CO2 Seal CO2 Puncture Tip Valve Spacer CO2 Valve Cap Valve Spacer O-Ring CO2 Valve Body O-Ring CO2 Valve Spring 12 13 14 1/16” X 7/8” Bright Finish All 15 Ball Pusher Body 16 Ball Pusher Top 17 Ball Pusher Base 18 Ball Pusher Spring 19 Mag Ball Retainer/Riser Knob 20 Magazine Slide Base REGULATOR ASSEMBLY NAME ITEM NO. NAME ITEM NO.
TROUBLESHOOTING FSC WARRANTY REGISTRATION CARD: PAINT BREAKAGE If you experience more than a small number of broken paintballs, check the following: 1. First, be sure that the marker is free of broken paintballs and other debris. 2. Second, make sure that the barrel is locked in its correct position, and that both detents are installed so that they catch a projectile as it enters the breach. 3. Third, make sure the maker is set to a reasonable velocity (never over 300 ft. per sec.) NAME: ADDRESS: 4.
FIRST STRIKE® Headquarters: 28101 Ballard Dr. Ste. F Lake Forest, IL 60045 Manufacturing/Warranty 2717 Ferguson Rd Fort Wayne, IN 46809 1-260-478-2500 service@first-strike.com FIRST-STRIKE.COM © 2017 United Tactical Systems. All rights reserved. This United Tactical Systems product is protected by United States and International Patents. United Tactical Systems Trademarks, Designs and Copyrights are protected by United States and International Law.
