User Manual

18 | FSC
™
19
PAINT BREAKAGE
If you experience more than a small number of broken paintballs, check the following:
1. First, be sure that the marker is free of broken paintballs and other debris.
2. Second, make sure that the barrel is locked in its correct position, and that both detents are
installed so that they catch a projectile as it enters the breach.
3. Third, make sure the maker is set to a reasonable velocity (never over 300 ft. per sec.)
4. Check bolt assembly. Remove bolt from upper receiver and check for bad o-rings or debris
5. Check magazine for debris.
6. Load rounds in magazine (without CO
2
cartridge installed) and engage PROJECTILE
RETAINER PIN - confirm that rounds can be ejected from the magazine without issue.
MY FSC HAS LOW VELOCITY OR DOES NOT FIRE!
1. If running a remote, make sure your output pressire is above 800psi and is
functioning properly.
2. Remove bolt from upper receiver, and re-install. The FSC is designed to not function
if the bolt is installed incorrectly.
TROUBLESHOOTING
NAME:
ADDRESS:
DATE OF PURCHASE:
SERIAL NUMBER:
Please detach from product manual,
place in stamped envelope and send to:
First Strike Paintball Warranty Support
2717 Ferguson Rd.
Fort Wayne, IN 46809
FSC WARRANTY REGISTRATION CARD:
"