User Manual

8 | FSC
™
9
4. LOAD PROJECTILES - Insert a maximum of 6 projectiles
into the magazine from the top (Diagram 1). The projectiles
will be held in place automatically by the projectile retainer
pin. You can also lock the Projectile Follower in the down
position by pulling down on the Projectile Follower
ears. FSR projectiles must be oriented as shown in the
illustration. (Diagram 2)
5. LOADING C0
2
CARTRIDGE - Obtain an 8 gram CO
2
cartridge.
Insert the CO
2
cartridge into the CO
2
slot of the magazine
with the small end of the CO
2
cartridge pointing up and into
the puncture pin of the magazine (Diagram 3)
6. SEALING THE CO
2
CARTRIDGE - If the FSC™ will be used
immediately, place the magazine into the FSC™ and seat
it fully. Pull down the Flip Knob Base Screw (Diagram 4)
and turn clockwise until the small end of CO
2
cartridge just
touches the puncture pin. Then, quickly turn the flip knob
clockwise until the cartridge is punctured and sealed.
Ensure that no CO
2
gas is escaping from the puncture
pin area.
7. STAGING - If the FSC™ will not be used immediately and is
only being staged for future use, tighten the flip knob base
screw until the small end of the CO
2
cartridge just touches
the puncture pin. Be sure the pin does NOT puncture the
CO
2
cartridge.
FOLLOWER
EARS
LOAD PROJECTILE
Diagram 1
Diagram 3
Diagram 2
Diagram 4
FLIP KNOB
BASE SCREW
OPERATIONAL INSTRUCTIONS
8. LOAD MAGAZINE - Place the magazine in the grip of the
FSC™ as illustrated below. Once the magazine has started
into the grip seat continue to insert the magazine until it is
secured by the magazine catch. Follow the steps outlined for
immediate use in step 6 of Getting Started.
SET VELOCITY
1. Insert provided 3/16” Allen wrench as depicted.
2. To increase velocity, tum clockwise. To decrease velocity
turn counter-clockwise.
3. Fire once to clear chamber after each adjustment, then
measure velocity of the
second shot.
NOTE: If magazine does not lock on
first insertion, remove it completely
and reinsert.
OPERATIONAL INSTRUCTIONS