User Manual

10 | FSC
™
11
CLEANING
• Never perform maintenance on a loaded or pressurized FSC Pistol
• Remove all projectiles from the magazine and marker prior to doing any cleaning or maintenance.
Never use petroleum based cleaning solvents or lubricants.
• Do not use cleaning solvents that come in aerosol cans.
• To clean the FSC Pistol, remove the barrel as described in the “Operational Instructions”. Use a .68
caliber soft nylon brush or 12 gauge patch tip with a soft cotton cloth to clean the barrel. Do not place
lubricant or water in the barrel of the FSC Pistol. It is designed to be used with the barrel completely dry.
This is a great time to check the ball detents for any wear or damage.
• Wipe off any dirt or grime from the outside of the FSC Pistol with a dry cloth.
OILING THE MARKER
IMPORTANT: Before performing any of the following instructions, remove magazine.
Point marker in safe direction and discharge until degassed.
FOR OPTIMUM PERFORMANCE, DO THE FOLLOWING MONTHLY:
• Place 2 drops of NON-PETROLEUM BASED synthetic paintball marker oil into the top end of the CO
2
Cavity of your FSC Magazine before installing the air source. When the marker gases up the air will blow
the oil through out the internals of the marker.
OPERATIONAL CONSIDERATIONS
• The operational temperature range for the FSC Pistol is 37° F to 120°F.
• The FSC Pistol is designed to operate on a minimum of 800psi of air pressure. If you choose to run a
remote, double check your tank output pressure by using a First Strike Air Pressure Kit(Sold Seperatly).
FSC CLEANING & MAINTENANCE
First Strike
®
warranties to the original customer purchaser or current owner that this product
is free from defects in material and workmanship under normal use and service for a period of
12 months from the original date of purchase by the initial owner/purchaser.
For warranty to be effective, customer must return the First Strike
®
Warranty Registration
card that came with the product within thirty days of purchase or complete the online
warranty form. First Strike
®
agrees to repair or replace (at its discretion) any product within
a reasonable period of time. This warranty does not cover o-rings, scratches, nicks, normal
wear and tear of parts, any modifications or normal fading of anodizing or damage caused by
dropping or hitting of products. This warranty shall not apply if it is shown by First Strike
®
that
the consumer caused the defect or malfunction because of misuse. This warranty only covers
original factory parts. Any modifications or tampering of original factory parts will not be
covered by this warranty. Any damage caused by water will not be covered by this warranty.
If your paintball product requires repair, please package it carefully and send together with
your name, address, phone number, and a brief description of the malfunction to:
First Strike Warranty Support
2717 Ferguson Rd
Fort Wayne, IN 46809
Phone Free: 260-478-2500
9:00am-4:00pm Eastern / Mon-Fri
Note: Always remove the air source or degas the marker while not in use.
WARRANTY & REPAIRS