Voyager User's Manual

RAID Controller Configuration
4-19
4. Sync Transfer Clock: this option allows the user to adjust the transfer rate of
synchronous data transfers along the bus or to select the asynchronous mode of
operation.
5. Wide Transfer: this option allows the user to enable or disable wide transfer mode.
6. View and Edit SCSI Target: when this option is selected a screen similar to that in
Figure 4-37 is presented.
By using the Up and Down Arrow keys the user may scroll down to ID 15.
Select an ID to be viewed by highlighting it and pressing e on it. The following options
are presented:
1. Slot number
2. Maximum Sync. Xfer Clock
3. Maximum Xfer Width
4. Parity Check
5. Disconnect Support
6. Maximum Tag Count
7. Resume to Default Settings
1. Slot Number: this option allows the user to assign a slot number to the drive in the ID
chosen.
2. Maximum Sync. Xfer Clock: this option allows the user to set the maximum
synchronous transfer speed in 4ns units.
3. Maximum Xfer Width: this option allows the user to set the maximum transfer width for
data at either narrow or wide.
4. Parity Check: this option allows the user to enable or disable parity checking.
5. Disconnect Support: this option allows the user to enable or disable target disconnect
6. Maximum Tag Count: this option allows the user to set the desired maximum tag count.
7. Resume to Default Settings: this option allows the user to restore the default settings for
the selected ID. Figure 4-37 shows the default settings for the Voyager 3000 system.
Figure 4-37 View and edit SCSI target