User's Manual

| coded remote controllers by code injection method. And by this method, in
case of |
| loosing remote controller the user can let system go into "valet".
|
|
|
| The injection method is as follows
|
| ButtonI,IV:Should be Touched II , III : Should be pressed for 2
seconds |
|
|
| (1) Complish installing system in the car
|
| (2) Prepare remote controllers(up to three ones) to be used
|
| (3) Put the key in the key hole and place to 1st step(ACC)
|
| in the key box.
|
| (4) Once place the 2nd step(ON) and return to 1st step(ACC).
|
| (Apply this more then 3 times within 3 seconds)
|
| ----> just after this the light(dirrection-light)will blink once.
|
| (5) Touch(or Press) the prepared remote controller button I,II,III,orIV
|
| ----> just after this the light(dirrection-light)will blink once.
|
| At this time the button number is related with system option
|
| The option is classified as follows by button number
|
| Button I,II ; General vehicles
|
| Button III ; Vehicles that automatically unlock doorlock just after
"engine off"|
| Button IV ; Vehicles that use air lock/unlock system(The system's
lock/unlock |
| time is 4 second
|
| (6) Touch(or Press) another remote controller button. Don't care button
number. |
| ----> just after this the light(dirrection-light)will blink once.
|
| (7) Touch(or Press) the other remote controller button. Don't care button
number. |
| ----> just after this the light(dirrection-light)will blink twice.
|
| : Injection end 24
|
| During these steps, after step(4) the key should be located at "ACC"
|
| and after injection you can use remote controllers (used in injection)
|