User Manual

23
Q10: How do I adjust the Date and Time?
A:
First way: Verify that your system have a healthy network. Right click the mouse
from the home screen of your monitor, navigate to System setup>Network Setup.
Check to see that Network Status says Healthy Network. From the same Window,
select General setup>Time setup from the left menu bar. Select Enable>Sync now,
click ok.
Second way: Navigate to System Setup>General setup&Time setup, please unse-
lect Enable>Select correct System Date & System Time and click Apply. Click ok.
Q11: I have my cameras set up outdoors for motion type record-
ing and I notice there is much more motion detected at night than
during daylight. In fact, most recordings show no large object
moving at all, only small dots and streaks of light. Why is that
and is there anything I can do about it?
A:
At night the area is illuminated by infrared LEDs. Rain or other precipitation near
the lens is highly illuminated by the LEDs. Insects are also attracted by the LED
light and are also highly illuminated. Try lower the sensitivity settings on the camer-
as to minimized false recordings. You could also try mounting the cameras under a
building overhang that will block rain from passing too close to the camera lens.
Q12: What is the working temperature of Firstrend Security Cam-
eras.
A: Camera working temperature: From -50 degrees Fahrenheit to +122 degrees
Fahrenheit.
Q13: How do restore my unit to the Factory Settings?
A:
Right click the mouse from the home screen of your monitor, navigate to System
setup > System admin > Factory setting, click all, click OK. Next, right click the
mouse from the home screen of your monitor and navigate to Video manage, click
Refresh, click Auto add, after all IP addresses appear, click OK. All videos will
appear on your monitor screen.
2. Please don’t put two cameras too close, they may cost interference to each other.
3. Metal or glass blocks signal a lot. Avoid putting cameras behind these obstacles.
4.Contact [e-mail] if more assistance is needed.