User Manual

Q17: I connected the system, why nothing is showing on my
monitor?
A: Step1: Please make sure your TV/PC Monitor has been set to HDMI Mode and
you are connected to its HDMI port. Be sure the HDMI cable is tightly connected.
Step2: The resolution of your TV/PV Monitor must be 1080P or higher. Since the
output resolution of our system is 1080P any TV/PC Monitor with lower resolution
would not be compatible. Try to connect the NVR to another monitor with higher
resolution. When the videos appear, you may need to adjust the NVR to a lower
resolution level, such as 1024*768, to allow the videos to properly display on the
screen. If so, right click the mouse on your home screen and navigate to System
Setup Setup>General Setup>Screen Setup. Select an appropriate display resolution
for your monitor and click “Apply” to save.
Picture IRON Location Meaning
Green bar
Red dot
Red Triangle
Little Yellow man
Top Right Corner
Top Right Corner
Bottom Left Screen
Top Right Corner
Wireless Signal
Recording
Alarm
Motion Detection
!
Q14: My system doesn’t recognized its hard drive?
A:
First confirm that the power adapter for NVR is 12V-2000mA. Once you have
confirmed, right click the mouse from the home screen of your monitor and navigate
to System setup > General setup > HDD setup. Verify if there is HDD information,
select hard drive information, click Format>OK .If there is no hard drive information,
open the NVR box and check to see if the cable of hard drive is loose. Re-connect
the HDD cable.
Q15: What if I forgot my login password?
A:
please call us at 1-888-426-4118 or send an Email to [e-mail],
update us your phone number. Email subject: Request Password Reset. So that we
call and give you super password to login.
Q16: What's the meaning of IRON on the TV/PC monitor?
A:
24