Instructions / Assembly

Pre-Installation

The Installation should be completed on an asphalt/concrete surface, with sufficient area to work. Un-

package your new FRISTTRAX Snowplow, discard all shipping materials, recycle if possible. Once the plow is

un-packaged, slowly roll the plow from its upright shipping configuration over onto the built-in cart. Top up

the oil reservoir to the fill line indicated with the 1L of hydraulic oil provided. Your new FIRSTTRAX Snowplow

is now ready to be installed.

Installation

Step 1 – Install mounting brackets and cross bar.

Please follow the instructions included in your mount kit. Fit in place with all fasteners (finger tight) then

proceed to tighten with appropriate tools.

Step 2 – Install the main power cord.

**ALWAYS EXERCISE CAUTION WHEN USING HAND TOOLS AROUND THE BATTERY! A SOLID

CONDUCTER SUCH AS A METAL WRENCH CAN CAUSE SEVERE INJURY, FIRE, OR EVEN CAUSE THE

BATTERY TO EXPLODE!

Attach the short lead on the breaker to the positive “+” terminal of the battery. Secure the breaker to the

fender or firewall with the use of screws or zip ties in a place where it will not come into contact with the

negative terminal. Attach the negative lead to the negative “-“battery terminal. Route the wires from the

battery in the best possible way to the front of the vehicle avoiding areas that can become hot or cause

friction when the vehicle is in use. Zip tie the wires to the vehicle’s structure so that they do not move or

shift when in operation. Confirm the breaker is in the closed position, and then close the hood slowly to

make sure yet again that the wires are clear from pinch points.

PAGE 1
Pre-Installation The Installation should be completed on an asphalt/concrete surface, with sufficient area to work. Unpackage your new FRISTTRAX Snowplow, discard all shipping materials, recycle if possible. Once the plow is un-packaged, slowly roll the plow from its upright shipping configuration over onto the built-in cart. Top up the oil reservoir to the fill line indicated with the 1L of hydraulic oil provided. Your new FIRSTTRAX Snowplow is now ready to be installed.
PAGE 2
Step 3 – Attaching the snowplow to the vehicle. Roll the plow to the front of your vehicle. The channel on the snowplow lift frame is to fit around the cross bar on the mount. Helpful hint…have the channel which is to slide over the front cross bar parallel to the ground. To alter placement simply push or pull on the control box which will allow you to change the current resting place.