Installation Sheet

7
6 CUSTOM DRAWER PANEL SPECIFICATIONS
The following calculations assume the top of the upper panel is
aligned with the top of the adjacent cabinetry.
WIDTH OF THE PANEL
Measure A (the width between adjacent door/drawer fronts)
and write it in the first box below, then complete the equation.
HEIGHT OF THE PANEL
1/16” (2mm)
Ventilation Gap
min. 1/16” (2mm)
with External Venting
Kit installed
Ventilation Gap (min. 1/16” (2mm))
with External Venting Kit installed
min. 1/16” (2mm) min. 1/16” (2mm)
min. 1/16” (2mm)
WIDTH OF PANEL
HEIGHT OF
PANEL
PANEL
B
A
A
B
Clearance to adjacent
cabinet front
(min. 1/16” (2mm))
(min. 1/16” (2mm))
(23 7/16”-24 3/16” (596-615mm))
Ventilation Gap
WIDTH OF PANEL
HEIGHT OF PANEL
Note: when the top of the dishwasher
has to be lower than the adjacent
cabinetry, the top of the panel can
extend above the chassis where required,
however a min. 1/16” (2mm) gap to
the benchtop must be maintained.
- 2x =
=-
FRONT PANEL MATERIAL SPECIFICATIONS
●
5/8 - 13/16” (16 - 20mm) panel thickness
●
Adequately sealed to withstand moisture (122
O
F/50
O
C @ 80% RH)
Because of it being a hot and wet environment generally, the back and sides of the
panel should be completely sealed with a waterproof vapour barrier (ie polyurethane)
to prevent damage to the panel.
●
The back of the panel (including any integrated handle) should be completely flush so
that the seal between the panel and the rubber trim is maintained.
●
Installation outside these specs may result in condensation on cabinetry surfaces.
●
Maximum weight of panel: 20lb (9kg)