Installation Guide

15
!0 ELECTRICAL AND PLUMBING
ELECTRICAL SPECIFICATIONS FREEZER REFRIGERATOR
Supply 115VAC, 60Hz 115VAC, 60Hz
Service 10 amp circuit 10 amp circuit
Outlet 3-prong grounding-type 3-prong grounding-type
Power cord (excluding plug) 86” (2190mm) 86” (2190mm)
PLUMBING SPECIFICATIONS FREEZER REFRIGERATOR
Supply 1/4” (6mm) comp. Stainless steel braided hose NA
Pressure kPa (psi) min 150 (22) / max 827 (120) @ 68°F (20°C) NA
Water inlet hose 831/2” (2121mm) 831/2” (2121mm)
A
BB
C
Left side of cavity
Electrical and water connections must be within this space if located
behind the appliance and must not protrude from the back wall.
REAR OF CAVITY
ELECTRICAL AND PLUMBING DIMENSIONS inches (mm)
A
Overall height of supply area 9” (229)
B
Width from the side of the cabinetry 1/2” (13)
C
Height at sides of supply area 5” (127)
Note: Dimensions are based on minimum depth of cavity.
Image shown is for single install.
For dual install, each appliance should have a separate power supply connection with only the
freezer having a water connection.
Floor
Note: We recommend to use an isolating switch that is easily accessible to the user after the
appliance is installed.
WARNING!
Electric shock hazard! Assume all parts live. Disconnect supply before servicing
and installation.