Installation Guide
16
!2 CONNECT TO WATER AND ELECTRICAL SUPPLY
IMPORTANT!
The water connection instructions below are intended only for the professional installer.
Water fittings are not included in the refrigerator and must be purchased separately.
Fisher & Paykel water fittings are available (part number: 841301) and comply with local regulations.
Ensure the refrigerator is NOT plugged into a power supply.
Ensure there is enough tubing for the water connection and to pull the refrigerator outforservice, if required.
REAR VIEW
2
At the front of the product, dislodge the PRV.
Grasp the PRV from the clips by pulling ittowards you (A).
FRONT VIEW
A
3
Firmly insert water tubing into the PRV. The tube should push in at least
5/8” (16mm) before reaching the stop. Once inserted, pull gently on tubing
to ensure it is locked in(B).
Secure the connection by attaching the locking key in between the
PRVand water tubing (C). Mount the PRV back into the clip.
C
B
1
Uncoil the 1/4” (6mm) water tubing and thread one end through
the opening intherear cover until it exits the front.