Installation Guide

22
!7 HANG NON-WATER DISPENSING DOOR PANELS
IMPORTANT!
Remove the protective film before hanging
thedoor panels.
1
Hang all door panels onto M8 studs and
alignthe side bracket forks onto the
refrigeratordoor (A).
– Ensure the forks are positioned around
thebody of the side screws (M5x10 pan
head Phillips screw).
2
Push the product until the door panels are flush.
– Depending on your installation design this
will be flush with your adjacent cabinetry
or your framework.
3
Place a ruler on the front of the product to check
flushness top and bottom, left and right (B).
4
Ensure the gap between the top of the door
panel and the top cabinetry is no greater than
1/4” (7mm).
– To reduce this gap, raise the product
byturning all four adjustment nuts the
same number of turns.
IMPORTANT!
Failure to follow these steps can lead to
difficulties in door panel adjustment and
cosmetic cap fitment.
5
Lock top inner panel side screws to allow
opening the doors without affecting
adjustment. (Open the left door to lock the
right screws and vice versa (C).)
For Fisher & Paykel Stainless steel door panels only.
E
D
6
All door panels have
full axis adjustment to
ensure they are flush
with adjacent walls.
To adjust the height
of each panel, turn
the stud clockwise
to raise or counter-
clockwise to lower
the door panel (D).
7
Once satisfied with
the alignment, secure
M8 studs with M8
washer and M8 nut
(E). The top of the
stud must remain
below the top face of
the door panel.
8
Secure side bracket forks by tightening
side screws (F).
Repeat this process for all door panels.
Note:

For depth adjustment loosen side screws x4,
adjustpanels and then retighten oncesatisfied.

Further adjustment of door panels can be achieved
by removing door panels then loosening the fixing
screws for the hanging bracket and moving the
bracket sideways to suit.
Place a ruler on the
front of the product to
check flushness top and
bottom, left and right.
B
A
F
C