Installation Guide

10
7 CUSTOM DOOR PANEL INSTALLATION DIMENSIONS
The drawings below apply to non-Water dispensing models only RS36W80J. Dimensions apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
TOP PANEL – REAR VIEW
153/16” (386mm)
51/16”
(129mm)
11/8”
(29mm)
37/16”
(87mm)
193/8” (492mm)
215/16” (541mm)
163/8” (416mm)
All measurements to be made
from top and centerline.
BOTTOM PANEL – REAR VIEW
Cutouts are located in attachment bracket for Fisher & Paykel handle only.
Iflocatingcustom handle in the shaded area shown above, ensure handle screw
headsare countersunk into back of panel to avoid interference with hanging bracket.
Ensure handle is mounted
29/16” (65mm) from edge of
panel to the center – this will
avoid interference with bracket.
17/16” (37mm)
341/4” (870mm)
22” (508mm)
415/16”
(125mm)
615/16”
(176mm)
2415/16” (633mm)
2615/16” (684mm)
385/8” (981mm)
301/16” (764mm)
All measurements
to be made from
bottom left corner
1311/16” (348mm)
59/16”
(141mm)
Ø 3/32” (2mm) REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
40” (1016mm)
Ø 3/32” (2mm) REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).