Installation Guide

19
!4 CONNECT TO WATER AND ELECTRICAL SUPPLY
6
Thread the free end of the water line hose into the hole located at the base
of the refrigerator (C), and through the back of the refrigerator.
7
At the back of the refrigerator, loosely coil the water line hose (
~
2 – 3 times)
and fasten the end of the hose to the cold water supply (D).
Note: Do not over-tighten the connection. Turn the isolating faucet on and
check that all connections are dry and free of drips.
8
At the back of your refrigerator, connect the refrigerator to the electrical supply (115VAC, 60Hz) with the
fitted plug and lead, and turn on. Ensure the refrigerator is connected to its own isolating switch (E).
IMPORTANT!
Follow the steps below to avoid running over the hose that can cause damage and possible waterleaks.
WARNING!
Failure to follow this instruction can lead to serious injury or death.
9
Pushing the refrigerator into the correct position:

Stop midway, reach through base to locate power cord. Pull power cord through the front left side
of the refrigerator (F), tucking it neatly in the left side of the base (G).

Reach through base to locate water line hose coil. Tuck coil neatly into front right side of base (H).

Push the refrigerator until the doors are in line with the frame. Ensure refrigerator is centered.

Firm contact must be achieved between the refrigerator and anti-tip bracket, 23/8”min.(60mm)
overlap (I ).
D
C
23/8” min.
(60mm)
overlap
I
Final location
of power cord,
left side of base
G
Final location
of water tube,
right side of base
H
E
F