Installation Guide

27
@2 ATTACH COVERS AND DOOR/DRAWER TRIMS
1
If applicable, remove any remaining protective
film on your door panels.
2
Open the refrigerator door, firmly push top
cover (A) over the top studs.
3
Door side trims
Install the side trims by inserting into the
panel gaps on each side of the door(s) (B).
Align the trim to the top of the door
andpress evenly into the panel gap
untilfully seated (C).
4
Press the double-sided adhesive tabs
together to form pairs (D) and remove
theadhesive backing on one side only.
Press firmly to install on the underside
of the drawer top trim in the indicated
locations (E).
E
D
5
Drawer side trims
Install the side trims in the same manner (refer to step
3
).
6
Drawer top trim
Remove the remaining adhesive backing from the double-sided adhesive tabs.
Locate the trim against the back surface of the panel and press down firmly.
Ensure the trim is fully seated against the drawer surface.
A
B
C