Installation Guide

29
IMPORTANT!
Before installing your refrigerator, ensure the dimensions of the finished enclosure are correct for your refrigerator following the‘Product and cavity dimensions’ sections.
A
PlasticAluminum
For 80” (2032mm) cavity installation only
2
Measure 4” (102mm) from the top, shorter
side trim and carefully cut using a fine
tooth hacksaw to a length of 76“ (1930mm).
Referto (A) for orientation of side trim.
Note: Ensure cut is straight and square
as this is an exposed surface. Also ensure
the plastic part does not bend as this can
causevisual stress marks.
Repeat this process for the remaining
sidetrim.
@4 ATTACH SIDE TRIM BRACKETS – [A] FLEXIBLE SPRING CLIP METHOD
TWO METHODS ARE AVAILABLE FOR ATTACHING SIDE TRIM BRACKETS:
[A] FLEXIBLE SPRING CLIP METHOD – RECOMMENDED METHOD
[B] FIXED SCREW METHOD – METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method [A]. If method [A] results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method [B]).
3
Position 3 side trim brackets onto each side trim.
Note: Measure from the top of the trim, with the
shorter lip at the bottom. (Refer to (B) for 80”
and 84” bracket locations and trim orientation.)
IMPORTANT!
Each bracket has two engagement points
for the side trim to locate. Ensure the trim is
engaged in both points (C).
Repeat this process for the remaining side trim.
1
Break off the datum lip to each side
trim bracket and discard.
Repeat for all side trim brackets.
80” = 9” (229mm)
84” = 13” (330mm)
80” = 36” (914mm)
84” = 40” (1016mm)
80” = 65” (1651mm)
84” = 69” (1753mm)
0
B
Discard
Top view of side trim engaged
correctly in side trim bracket
C
Side trim
bracket
Side trim