Joiner Kit Guide

7
9 LOCATION OF PRODUCTS INTO ALCOVE — LEFT PRODUCT
A
IMPORTANT!
Open the door of the right hinge product.
1
Roll the left hinge product into the left hand side of the alcove until the product makes
contact with the joiner bracket (refer to A).
IMPORTANT!
For flush installation: check for flushness of the product with the adjacent product (refer
to separate ‘Installation instructions’ booklet supplied with your appliance on how to
achieve flushness).
2
Open the left hinge product door to access the brackets (refer to B).
3
Adjust the product height (as per the separate ‘Installation instructions’ booklet supplied
with your appliance), so holes in the top trim are in line with the holes in the joiner bracket
(refer to C).
– Note: for clarity of drawing, top trims are not shown.
4
Screw two M5 x 12 Socket head cap screws to fix left hand top trim to the joiner bracket
(refer to C).
B
C