Quick Start Guide

26
!6DUAL INSTALLATION
IMPORTANT!

Ensure the doors are in line with the cabinetry front and the appliance is centered.

All four corners of the appliance must be supported firmly onto the floor to eliminate any
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Fixing the first appliance inside the cabinetry
1 Fix each top bracket of first appliance to ceiling surface with two (2X) 8Gx16 countersunk
screws (B).
– 18” (457mm) column = 1 bracket
– 24” (610mm) column = 2 brackets
– 30” (762mm) column = 2 brackets
Note: Ensure the appliance does not move as you open the door when you install the
screws.
2 Fix the alcove side bracket to alcove side surface with one 8Gx16 countersunk screw (C).
Note: Image shows 18” first appliance with 1 top bracket.
Required components/tools:

Phillips screwdriver or power driver

5x 8Gx16 countersunk screws (840597)
B
C
alcove side bracket
C
B
2 Continue turning the adjusting screws alternately between front and rear feet until
you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the appliance by
alternately adjusting the front and rear feet until the top surface contacts the
alcove ceiling.

Check the alignment gauges while adjusting the screws to make sure you
maintain the alignment of the appliance.
4 Ensure all feet are positively engaged with the floor.
Rear footFront foot
A
Front foot
adjustment
Rear foot
adjustment
1 Turn the front and rear adjustment
screws using a Phillips screwdriver
(or powered driver) to extend the
feet until it engages the floor.
– One turn of height adjusting
nuts is equivalent to 1/32”
(0.5mm) of height adjustment.
Clockwise turn raises the
height and counter-clockwise
turn lowers height (A).
Adjusting height of the appliance inside the cabinetry